mediarelop.blogg.se - Mrx2 urc programming software

You can continue to pair devices while in pairing mode.ĥ. The ready light will quickly start flashing for 2 seconds to verify the device has been paired.Ĥ. Go to the device you wish to pair and perform its instructed pairing method.ģ. The Ready light will slowly flash to show it is ready to pair a device.Ģ. + (pairing button): Stated above the TRF-ZW1 defaults to Pairing (Include) when battery power is activated.ġ. By default the unit goes into Pairing (Include) mode automatically. After 10 more seconds the ready light will start to flash amber.The Power light will start to flash Blue for 30 seconds.Press and Hold the “Battery” icon on the top of the unit for 5 seconds.

Insert 4 AA batteries into the bottom of the unit.ģ. Disconnect the TRF-ZW1 from the network and power cable.Ģ. īattery button: This button is used to enter battery pairing mode while pairing devices in various locations.ġ. Network: Illuminates to indicate communication to the home network.Įrror: Please consult the troubleshooting section of the URC MIOS documentation site. Ready: Illuminates to indicate it is ready to receive data. Power LED: Illuminates to indicate the TRF-ZW1 is powered. Register a free account for basic control and Z-Wave configurations from home, or subscribe to a yearly account to access theTRF-ZW1 from anywhere else. Remote Device Management & ConfigurationĪccess theTRF-ZW1’s user interface via its online site whether you are at home or away.The included batteries allow for roaming and easier pairing of hard-to-reach Z-Wave products installed throughout the home.

While using applicable URC two-way modules, monitor Z-Wave products with metadata feedback on aTotal Control remote, keypad, or mobile device. Also, while at home or away, control your Z-Wave products using URC’s mobile apps from your mobile devices. YourTotal Control system receives commands, converts them to Z-Wave signals and then transmits the signals to your products.

Control Z-Wave products with yourTotal Control system.

Some compatible third-party products are capable of sending metadata back to aTotal Control user interface when using URC’s two-way modules. The Z-Wave Extender receives commands from aTotal Control system and sends those commands over the Z-Wave network to third-party products such as door locks, lights etc. Thank you for purchasing URC’sTRF-ZW1 Z-Wave Extender for theTotal Control system.